Page 1 of 1
No data
Posted: Fri Apr 30, 2010 7:28 am
by Gerrit
Hello.
After one of updata meteohub, 4.6f version is no more data to plug meteo,
I can plug it in meteorological sensors see.
Server log shows the following error message guide:info: Apr 30 09:18:28 gamma LOGRAW 00:0D:B9:0D:56:50: WAN IP 86.87.128.90: no raw data
to inspect data I see *** End of data ***
Regards, Gerrit
Re: No data
Posted: Fri Apr 30, 2010 9:37 am
by admin
Please goto settings page on Meteohub and change upload interval and press "save". That should start transmission of data again.
I will try to find this bug and fix it with next Meteohub version.
Re: No data
Posted: Fri Apr 30, 2010 12:23 pm
by Gerrit
Hello
I have put the upload in 10 minutes, so far without success.
Regards, Gerrit
Re: No data
Posted: Fri Apr 30, 2010 1:23 pm
by skyewright
Gerrit wrote:I have put the upload in 10 minutes, so far without success.
In the interest of experimentation I just tried this too, including chaging the update time (10 mins => 15 mins) then using Save on the settings window (which schedules another recalculation - should that be necessary?), and so far I'm seeing just the same as Gerrit.
Boris: Is there somewhere on the Meteohub could we check to see if data is being cached, e.g. via SSH & ls or cat?
Re: No data
Posted: Fri Apr 30, 2010 4:31 pm
by admin
please update to 4.6g - that should fix that bug.
Re: No data
Posted: Fri Apr 30, 2010 5:12 pm
by skyewright
admin wrote:please update to 4.6g - that should fix that bug.
Now using 4.6g (Build 3290).
There was no raw data on the initial or second (i.e. 15 minute later) connection with Meteoplug, so I then used Settings to change back to 10 minute uploads, then Saved.
Data is now flowing again. Thank you.
There is a gap since the 4.6f update, but since this is Meteohub based data the gap should be easy to fill with an "Import" of Meteohub 'raw' data.