No data

[Gerrit]

Hello.

After one of updata meteohub, 4.6f version is no more data to plug meteo,
I can plug it in meteorological sensors see.
Server log shows the following error message guide:info: Apr 30 09:18:28 gamma LOGRAW 00:0D:B9:0D:56:50: WAN IP 86.87.128.90: no raw data
to inspect data I see *** End of data ***

Regards, Gerrit

[admin]

Please goto settings page on Meteohub and change upload interval and press "save". That should start transmission of data again.

I will try to find this bug and fix it with next Meteohub version.

[Gerrit]

Hello

I have put the upload in 10 minutes, so far without success.

Regards, Gerrit

[skyewright]

I have put the upload in 10 minutes, so far without success.

In the interest of experimentation I just tried this too, including chaging the update time (10 mins => 15 mins) then using Save on the settings window (which schedules another recalculation - should that be necessary?), and so far I'm seeing just the same as Gerrit.

Boris: Is there somewhere on the Meteohub could we check to see if data is being cached, e.g. via SSH & ls or cat?

[admin]

please update to 4.6g - that should fix that bug.

[skyewright]

please update to 4.6g - that should fix that bug.

Now using 4.6g (Build 3290).
There was no raw data on the initial or second (i.e. 15 minute later) connection with Meteoplug, so I then used Settings to change back to 10 minute uploads, then Saved.

Data is now flowing again. Thank you.

There is a gap since the 4.6f update, but since this is Meteohub based data the gap should be easy to fill with an "Import" of Meteohub 'raw' data.